USAGE INSTRUCTIONS
Unfolding the Table:
When unfolding the table, the
step is to lock the casters. Then, take caution so that all areas
around you are clear. Please remember, the table is very heavy. If you are worried that it may be
too heavy, it is recommended that at least two people unfold the table. To unfold the table, push
on the lock to release the table from the storage position. After unlocking the table, slowly lower
the table half down. Do the same for the other half. Check to make sure that the locking hinge bar
attached to each leg of the table is straight (locked). Then install the net and post set, and enjoy
the table tennis table.
Folding the Table:
To fold the table into storage position, the
step is to lock the casters. Next, ensure that the net
and post set have been removed from the table. Failure to do so could cause damage to the table
when trying to fold the table with the net and post set still attached. Then, unlock (by bending) the
locking hinge bar to enable the H-bar to be stored against the bottom of the table surface. Please
remember that the table is very heavy. Ensure that you have enough ceiling height to raise the
table half. If you are worried that the table will be too heavy for you to lift, it is recommended that
at least two people fold the table. Raise the table half to the vertical position until you hear a loud
clicking noise and make sure that the lock is fully engaged.
Playback Position:
Playback position is achieved by unfolding one half of the table and folding the other half. Make
sure that the locks of the folded half are fully engaged. Always use the locking casters and place
them in lock position when the table is in playback position for added safety.
Leveling:
The table comes with leveling feet. Spin the leveling feet to adjust the height and make the table
level.
Using the locking casters
When the table is in storage position, or in play position, please remember to always lock the
casters for added safety.