Startingthe Engine
WARNING!
This tractor
is equipped
with a safety
interlock
system designed
for the protection
of the
operator.
Do not operate the tractor if any part of
the interlock
system is malfunctioning.
Periodically
check the functions
of the interlock
system for
proper operation.
WARNING!
For personal safety, the operator
must
be sitting
in the tractor
seat when starting
the
engine.
1.
Operator
must be sitting
in the tractor
seat.
2.
Engage the parking
brake. Refer to Fig. 5-1.
3.
Make certain the PTO switch
is in the disengaged
(down)
position.
Refer to Fig. 5-1.
LH Control Lever
Out in Neutral
.....
j_______
l-arKing BraKe
_\
o_
Engaged
_ _----_L
Throttle
Control
to
(_
.
11
Pull Choke up to
1
_
,
FulIChoke
-J
PTO Switch
(Disengagedl
Position
RH Control
Lever
Out in Neutral
in Down
k_
j
Figure 5-1
4.
Move the choke control upward into the full choke position.
NOTE: If the engine is warmed
up, it may not be necessary
to place the throttle
control
in the choke position.
5.
Move the throttle
control
to midway
between
its SLOW and
FAST positions.
6.
Turn the ignition
key clockwise
to the "START" position
and release it as soon as the engine
starts; however,
do not
crank the engine continuously
for more than 5 seconds at
a time. If the engine
does not start within
this time, turn
the key to "OFF" and wait at least 15 seconds to allow the
engine's starter motor to cool. Try again after waiting.
If
after a few attempts
the engine
fails to start, do not keep
trying
to start it with the choke closed as this will cause
flooding
and make starting
more difficult.
7.
As the engine
warms up, gradually
pull the throttle
control
lever rearward
past the choke detent
position.
Do not use
the choke position
to enrich the fuel mixture, except
as
necessary to start the engine.
8.
Allow the engine to run for a few minutes
at mid throttle
before putting
the engine under load.
9.
Observe the hour meter/indicator
panel. If the battery
indicator
light or oil pressure light come on, immediately
stop the engine. Have the tractor
inspected
by your Cub
Cadet dealer.
C01d Weather Starting
When starting the engine at temperatures
near or below freezing,
ensure the correct viscosity motor oil is used in the engine and the
battery
is fully charged. Start the engine as follows:
I.
Be sure the battery
is in good condition.
A warm battery
has much more starting
capacity than a cold battery.
2.
Use fresh winter
grade fuel. Winter grade gasoline
has
higher volatility
to improve
starting.
Do not use gasoline
left over from summer.
3.
Follow the previous
instruction
for Starting
the Engine.
Using Jumper Cables ToStart Engine
WARNING!
Batteries
contain
sulfuric acid and
produce
explosive
gasses. Make certain the area is
well ventilated,
wear gloves and eye protection,
and
avoid sparks or flames near the battery.
If the battery
charge is not sufficient
to crank the engine,
recharge
the battery.
Ira battery
charger is unavailable
and
the tractor
must be started, the aid of a booster
battery
will be
necessary. Connect the booster
battery
as follows:
I.
Connect
the end of one cable to the disabled
tractor
battery's
positive
terminal;
then connect
the other end of
that cable to the booster
battery's
positive
terminal.
2.
Connect
one end of the other cable to the booster
battery's
negative
terminal;
then connect
the other end of
that cable to the frame of the disabled
tractor, as far from
the battery
as possible.
3.
Start the disabled
tractor following
the normal starting
instructions
previously
provided; then disconnect
the
jumper
cables in the exact reverse order of their connection.
4.
Have the tractor's
electrical
system checked and repaired
as soon as possible to eliminate
the need for jump starting.
Stopping the Engine
I.
Place the PTO switch in the "OFF" position.
2.
Move the RH and LH drive control
levers fully outward
in
the neutral
position.
3.
Engage the parking
brake.
4.
Move the throttle
control
to midway
between
the SLOW
and FAST positions.
5.
Turn the ignition
key to the "OFF" position
and remove
the
key from the ignition
switch.
NOTE; Always remove
the key from the ignition
switch to prevent
accidental
starting
or battery
discharge
if the equipment
is left
unattended.
PracticeOperation(Initial Use)
Operating
a zero-turn
tractor
is not like operating
a conventional
type riding tractor. Although
and because a zero turn tractor
is
more maneuverable,
getting
used to operating
the control
levers
takes some practice.
SECTION
S--
OPERATION