Descargar Imprimir esta página

PAPILLON 83726 Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

www.papillon.ferritalia.it
4) Secure the tube at both ends with clamps (4).
5) Awer assembly check all connec4ons to be 4ghtly fastened. Check all connec4ons with a soapy water solu4on. If bubbles
appear turn the cylinder gas control off and re4ghten the connec4on before re-tes4ng.
NEVER USE A FLAME TO PERFORM THIS TEST.
NOTE: the replacement of the gas cylinder should be done away from any inflamma4on source. The empty gas boZle must be kept
in proper place un4l its return to the seller.
USER INSTRUCTIONS
CAUTION: Check that the installa4on of the appliance has been made correctly It is essen4al to check the equipment at least once a
year to check that tube, valves, etc., are in good condi4on. In all appliances provided with a ring burner, the adjustment of the
primary air has to be made in the test phase, in accordance with the instruc4ons, rules and regula4ons: IT IS FORBIDDEN TO
MANIPULATE OR REMOVE THIS MECHANISM.
The manufacturer declines any responsibility for damages caused by improper installa4on or incorrect use of the appliance.
1) POSITION OF THE GAS CONTROL: the gas control is always opposite to the
corresponding burner.
2) USE OF COOKING VESSELS: The flame must not exceed the boZom of the pot or
pan. When possible, cover the container. This will have a major energy saving. The
preferred diameter of the cooking vessels is 25 to 50 cm.
3) POWER: slowly open the gas control by pressing down and turning the valve in an
an4clockwise direc4on approximately 1/4 of a turn. Use a Gas lighter and posi4on
this close to the edge of the burner to be ignited.
4) OFF: turn the gas control valve clockwise un4l it stops.
. MAINTENANCE
For a long life of the appliance, regular maintenance is required. Clean the appliance when it is cold with soapy water or non-
abrasive liquid detergents.
Awer cleaning always make sure that the ring burner is properly cleaned and that
he gas outlet holes are not obstructed.
ATTENTION: when the opening or closing of the gas control valve becomes difficult or does not work, do not force or DIY repair but
call for technical assistance immediately.
Regularly check the state of the rubber tube and, if necessary, change t even before the indicate date. If the appliance remains
unused for a long 4me, close the main circuit of gas. Pack the device in its packaging and store it in a safe and dry place.
MANUALE ISTRUZIONI - MANUAL - INSTRUCCIONES
FORNELLONE A GAS / GAS BURNER / HORNILLO
FERRITALIA Società Coopera4va. - Via Longhin, 71 - 35129 Padova – ITALY
www.ferritalia.it
83726

Publicidad

loading