Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO JUMP START YOUR CAR
WE STRONGLY SUGGEST TO VERIFY THE VOLTAGE OF THE CAR BATTERY IS 12V
BEFORE STARTING. IF IT IS BELOW 2V OR ABOVE 12.6V, IT CAN'T BE JUMP STARTED.
WARNING: When using this unit to start, make sure the positive and negative connections are correct,
otherwise the battery may explode.
1
Light
Setup
PSI KG/CM BAR
Light
TARGET
Setup
Press and hold the power switch (8) for
3 seconds to turn on the unit. Make sure the
battery level is over 50%.
3
Light
READY
M
Setup
Unit
Inflator
A f t e r t h e c o n n e c t i o n i s c o m p l e t e d ,
"READY"on LCD indicate a correct status
to start jump start. Start the car and do not
crank over 5 seconds.
Power
M
Unit
Inflator
TEST
3
Seconds
%
LOWMIDDLEFULL
2
V
%
Power
READYOVERLOAD
COOLING
M
Unit
Inflator
TEST
V
Power
TEST
2
1
2
Follow the steps below for jump start,
otherwise it could be dangerous:
1. Connect the red (+) clamp to the positive
(+) battery terminal.
2. Connect the black (-) clamp to the metal
part of the engine (negative ground) or to
the negative battery terminal.
3. Insert the jumper cable (16) into the jump
start port (1) of the device.
4
3
PSI KG/ C M BAR
Light
TARGET
Setup
4
After the engine is successfully started,
first pull out the jump start plug (16) of the
device and then remove the clamps from the
car battery, and then long press the power
switch (4) to turn the unit off.
63
3
2
1
LO WM ID D LEFULL
V
2
%
Power
READ Y OVERLO
AD
COOLING
M
Unit
Inflator
TEST
OFF
3 Seconds
Publicidad
