Descargar Imprimir esta página

Fanimation TORCH SHOWROOM Serie Manual Del Usuario página 8

Ventilador de techo

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Assemble Your Ceiling Fan (continued)
5. Route wires and safety cable through motor coupling
cover, canopy screw cover and ceiling canopy.
(Figure 5)
6. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue and orange wires and
safety cable through the hanger ball. Position the pin
through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan wobble.
(Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
Ceiling Canopy
Canopy Screw
Cover
8
Motor Coupling
Cover
Figure 5
Figure 6
Figure 7

Publicidad

loading

Este manual también es adecuado para:

Torch showroom fp8458 serieTorch showroom fp8458bl