Publicidad
Idiomas disponibles
Idiomas disponibles
Wall mounting
Use mounting hardware
which is appropriate for
the wall type and suitable for the weight of
charger and heaviest battery pack. If the
charger is installed without the correct
hardware, the product may be unstable and
cause property damage or personal injury.
Do not wall mount the charger where the
weight of the charger and battery cannot be
supported. If the strength of the wall mount
location is not sufficient to support the charger
and battery, the charger can fall off and cause
an injury.
Check to be sure that there are no hidden
live wires, water pipe, or gas pipe behind the
mounting area. Cutting or drilling into any of
these may cause serious injury or death.
Do not mount charger upside down or
inverted. Improper mounting may cause
property damage or personal injury.
The charger can be mounted to a wall using wall
mounting slots 8.
a.
Locate suitable mounting area on the wall.
See Fig. 3 for proper mounting orientation.
b.
Mark two points on a vertical line 3-25/64"
(86mm) apart.
Assembly
c.
Select the appropriate screws and anchors
(if necessary) for the material of the wall.
(Mounting hardware not included.)
d.
Drill into wall with appropriate drill bit.
If anchors are to be used, follow anchor
hardware manufacturer's instructions.
e.
Screw in two round-head screws (not
included) with a diameter of 13/64" (5mm)
to maximum 1/4" (6.5mm) into wall or
anchors. Leave approximately 1/8" (3.3 mm)
space between bottom of screw head and
wall.
f.
Position the charger wall mounting slots over
the mounting screws. Push charger towards
the wall and slide it down to secure charger to
mounting screws.
Note: Make sure the charger is securely
mounted and that it is tight against the wall.
Adjust screw exposure as necessary to ensure
the charger is flat against the wall.
8
Fig. 3
Publicidad
