GreenWorks LMC403 Manual Del Operario página 8

5.3 STORE THE MACHINE
• Clean the machine before storage.
• Make sure the engine is not hot when you store the
machine.
• Make sure that the machine does not have loose
or damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service
center.
• Store the machine in a dry area.
• Make sure that children cannot come near the
machine.
6 TROUBLESHOOTING
Problem Possible cause
The handle is The bolts are not
not in position. engaged correct-
ly.
The machine The battery ca-
does not start. pacity is low.
The bail switch is
defective.
The battery key
is not put in.
The machine The lawn is
cuts grass un- rough.
evenly.
The blade height
is not set cor-
rectly.
The machine Wet grass clip-
does not mulch pings attach to
correctly. the deck.
The mulch plug
is missing.
The machine is The grass is too
hard to push. tall, or the blade
height is too low.
The grass catch-
er and the blade
drags in thick
grass.
There is a high The blade is un-
vibration in the balanced and
machine. worn.
English
Problem
The machine
stops during
Solution
mowing.
Adjust the height
of the handle
and make sure
that the knobs
and bolts are
aligned correctly.
Charge the bat-
tery pack.
Replace the bail
switch.
Put in the battery
* If you cannot find the solution to these problems, go to
key.
the service center.
Examine the
mowing area.
Move the wheels
to a higher posi-
tion.
Wait until the
grass dries be-
fore mowing.
Install the mulch
plug.
Increase the
blade height.
Empty the grass
clippings from
the grass catch-
er.
Replace the
blade.
7
Possible cause Solution
The motor shaft 1. Stop the mo-
is bent. tor.
2. Remove the
safety key
and battery
pack.
3. Disconnect
the power
source.
4. Inspect for
damage.
5. Repair the
machine be-
fore you start
it again.
The blade height Increase the
is too low. blade height.
The battery pack Charge the bat-
is out of power. tery pack.
The grass clip- Remove the bat-
pings attach to tery pack and
the deck or the check the deck.
blade.
Operation tem- Cool the ma-
perature of the chine.
machine is too
high.
EN