Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and Maintenance Instructions
Pipe Mounting the Light
Attach the light to the 1-inch NPT pipe by threading the light
clockwise on the pipe (Figure 1). For information on making the
electrical connections, see "Wiring the Light" on page 9.
1" NPT
PIPE
Surface Mounting the Light
To mount the light on a flat surface:
1. Using the gasket as a template, scribe four drill-position
marks on the mounting surface (Figure 1).
2. Drill a 9/32-inch (7.1 mm) diameter hole at each of the
outside drill-position marks for mounting.
3. Drill or punch a 1-3/8 inch (34.9 mm) diameter hole at the
center drill-position mark for the wire entry.
4. Attach a suitable 1-inch NPT hub or connector to conduit
8
Figure 1 Mounting options
PIPE MOUNT
DRILL THREE 9/32"
(7.143 mm) HOLES
1/4" FLATWASHERS
Model 371LED-120 Rotating Light
371LED-120 LIGHT
ASSEMBLY
GASKET
MOUNTING
SURFACE
1/4" SCREWS
SURFACE MOUNT
290A6859
Publicidad
