Taurus SHA2310 Manual Del Usuario página 12

- Remove and clean one shaving head (B) at a time. (Fig. 4 & 5)
- Clean the cutter with brush (H) (Fig. 6) and install them on the
shaving unit.
- Put the retaining frame back into the shaving unit and turn the
safety lock clockwise.
- Attention: Do not clean more than one cutter at a time, since they
are all matching sets. If you accidentally interchange the cutters, it
could influence the shaving results.
FOR A QUICK CLEANING:
- Press the release button to open the shaving unit. (Fig. 2)
- Rinse the shaver head under the tap. (Fig. 8)
- The appliance has a cleaning reminder function.
- If the appliance has been used for more than 90 seconds, the
remaining battery% and the cleaning reminder icon (4) will be
shown on the screen for about 3 seconds, after the appliance is
turned off.
SAFETY PROTECTOR SENSOR
- The safety protector sensor prevents the product from operating
if it detects an excess of beard hair on the shaver heads. In this
case, the cleaning reminder icon (4) will appear on the screen ac-
companied by beeps for about 8 seconds and it will be necessary
to carry out a complete cleaning to continue shaving. (Fig. 9).
SUPPLIES:
- Supplies for your appliance model can be acquired from distribu-
tors and authorised establishments.
- Always use original supplies, designed specifically for your
appliance model.
- For optimal shaving performance, we advise you to replace the
shaving heads every two years.
- To replace the shaver head:
- Press the release button to open the shaving unit. (Fig. 2)
- Pull the shave unit upwards. (Fig. 10)
- Put the new shaving unit. (Fig. 11)
HOW TO REMOVE THE BATTERIES FROM
THE INTERIOR OF THE DEVICE:
- CAUTION: It is important that the batteries are fully discharged
prior to its withdrawal from the apparatus.