Black and Decker REVSD4C Manual De Instrucciones página 23

5. To stop the screwdriver, release the On/Off switch
Screwdriving Notes:
• Do not use double ended screwdriver bits.
• Do not use screwdriver as a pry bar in any position.
• To avoid screwdriver being turned on accidentally, do not
carry in your pocket.
Hints for Optimum Use
Screwdriving
• Always use the correct type and size of screwdriver bit.
• If screws are difficult to tighten, try applying a small
amount of washing liquid or soap as a lubricant.
• Always hold the tool and screwdriver bit in a straight line
with the screw.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of the
tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the
tool; never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered
by BLACK+DECKER , have not been tested with this
product, use of such accessories with this product
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your product
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact BLACK+DECKER call
1-800-544-6986 .
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you fi nd one day that your BLACK+DECKER
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for
separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand for
raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the retailer
when you purchase a new product.
.
1 Batteries
BLACK+DECKER batteries can be recharged many
times. At the end of their useful life, discard
batteries with due care for our environment:
 Run the battery down completely, then remove it from
the tool.
 NiCd, NiMH and Li-Ion batteries are recyclable.
Take them to any authorized repair agent or a local
recycling station.
SPECIFICATIONS
Voltage
No-load speed
Hard stall torque
Max. torque
Bit holder
Weight
*Maximum initial battery voltage (measured without a
workload) is 4 V. Nominal voltage is 3.6 V.
Integral Battery
Battery type
Capacity
ENGLISH
4 V Max*
180 RPM
5.5 Nm
5.5 Nm
6.35 mm
0.3 Kg
Li-Ion
1.5 Ah
21