Descargar Imprimir esta página

Avanti DGR20P3S Manual De Instrucciones página 15

Publicidad

Idiomas disponibles

Idiomas disponibles

 
HOW TO USE THE TOP BURNERS
 Control Knobs.
Each of the control knobs for the range is equipped with a ring of dual color LED status indicator lights
BLUE: When the knobs are in the OFF position the indicator lights will be in a bright blue color.
RED:
When the knobs are in turned to an ON position the indicator lights will be in a bright red to
indicate which burner is in use, the oven / broiler has been turned on or the function selector knob has
been turned to activate the rotisserie or to turn on the oven light.
 GAS BURNERS
Gas flow to the burners is adjusted by turning the knobs which control the valves. Turning the knob so
that the indicator line points to the symbols printed on the panel achieves the following functions:
When knob is rotated to the maximum position it will permit the rapid boiling of liquids, whereas the
minimum position allows the simmer warming of food or maintaining boiling conditions of liquids.
 
To reduce the gas flow to minimum, rotate the knob further counter‐clockwise to point the MIN position. 
Other intermediate operating adjustments can be 
achieved by positioning the indicator between the  M AX 
and MIN positions, and never between the MAX and OFF positions. 
When the range is not being used, set the gas knobs to their OFF positions and also close the gas shut‐off 
valve placed on the main gas supply line. 
 LIGHTING GAS BURNERS
In order to light the burner, you must:
1 – Push the knob all the way in, turn the knob in a counterclockwise direction up to the MAX
position (maximum rate) to ignite, and hold the knob until the flame has been lit and allow the system
to heat to the appropriate temperature and allow the flow of gas (approximately 10 seconds).
The sparks produced by the internal igniter will light the designated burner.
In the event that the local gas supply conditions make it difficult to light the burner in the MAX position,
try again with the knob in MIN position.
2 – Adjust the gas valve to the desired position.
To re-light the burner, return the knob to the OFF position and repeat the operations for lighting.
Caution! The range becomes very hot during operation. Keep children well out of reach.
 
ATTENTION:     FOR YOUR SAFETY: 
 
THIS UNIT HAS BEEN DESIGNED WITH A FLAME 
SENSOR SYSTEM THAT MONITORS THE COOKTOP 
BURNERS. 
 
When using the cooktop, press the knob all the way 
in, turn to ignite the flame and hold for 
approximately 10 seconds to allow the system to 
heat to the appropriate temperature and allow the 
flow of gas to the selected burner.
14
 

Publicidad

loading

Este manual también es adecuado para:

Dgr24p3s