Descargar Imprimir esta página

REV Ritter L17-1911S Instrucciones De Montaje Y Funcionamiento página 10

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
GB
SCOPE OF DELIVERY
Check the delivery for completeness and perfect condition.
In the case of missing parts or damage:
• do not mount the unit!
• do not put the unit into operation!
• make a complaint to the supplier.
The deliver consists of:
• Product
• Instructions
• USB charging cable
TECHNICAL DATA
• This product contains a light source of energy efficiency class F
• Output: 10W LED
• Illuminant: SMD LED´s
• Luminous flux: 1000lm
• Luminous efficacy: 100lm/W
• Colour temperature: 6500K
• Colour rendering index (Ra/CRI): ≥ 80
• LED service life: 25000h
• Beam angle: 120°
• IP protection class: IP20
• Protection class: III (S5)
• Ambient temperature: 0°C - 50°C
• Dimensions W x H x D: 120 x 170 x 40mm
• Weight: 425g
• Battery: 3,7V / 2x2200mAh / 16,3Wh / Lithium ion battery
• USB: Micro IN 5V DC / max. 2A; USB OUT: 5V DC / max. 2A
OPERATION
• Charging: Before (first) use, fully charge the product until the battery indicator lights up completely
• The product has a charging input with a Micro-B type socket. Only use the enclosed USB charging cable, which
can be plugged into a conventional USB power supply unit (socket: type A). Only use tested USB power supply
units with a maximum output voltage of 5V.
• Connect the USB charging cable to the charging input on the product and the USB power supply unit (A3).
• Charging time: 4 hours (depending on the selected USB power supply)
• Running time: 1 hour (1000lm) / 2 hours (400lm) / 4 hours (200lm)
• 1x press: full power (1000lm)
• 2x pressing: average power (400lm)
• 3x pressing: lowest power (200lm)
• Press four times: Off
CLEANING
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
MAINTENANCE
• Replace any damaged protective panels immediately (S6).
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire is not replaceable; if the light source has reached the end of its service life, the
entire luminaire must be replaced.
10
LED
Light source not interchangeable!
1
LED
1

Publicidad

loading