Descargar Imprimir esta página

Fanimation AMPED SHOWROOM Serie Manual Del Usuario página 8

Publicidad

Idiomas disponibles

Idiomas disponibles

How to Assemble Your Ceiling Fan (Continued)
5. Route wires and safety cable through motor
coupling cover, canopy screw cover and ceiling
canopy. (Figure 5)
6. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires and safety cable
through the hanger ball. Position the pin through
the two holes in the downrod and align the hanger
ball so the pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
8.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
Ceiling Canopy
Canopy Screw
Cover
Hanger Bracket
8
Motor Coupling
Cover
Figure 5
Figure 6
Figure 7
Figure 8

Publicidad

loading

Este manual también es adecuado para:

Amped showroom fp7634 serieShowroom serieShowroom amped fp7634 serie