Level Dryer; Connect Vent; Reverse Door Swing - KitchenAid KEHS01P Manual De Uso Y Cuidado

Ocultar thumbs Ver también para KEHS01P:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Lay the dryer door on a flat, protected surface with the inside
Level
Dl"yel"
door assembly facing up. Remove the last screw from Step 1.
Remove the 2 screws holding the handle to the door.
Check the levelness of the dryer. Check levelness first
side to side, then front to back.
If the dryer is not level, prop upthe dryer using awood
block.
Use a wrench to adjust the legs up or down and check again for
levelness.
NOTE: It might be necessary to level the dryer again after it has
been moved into its final position.
Connect Vent
1. Using a 4" (10.2 cm) clarop, connect vant to exhaust outlst in
dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured
to exhaust hood with a 4" (10.2 cm) clamp.
2.
Move dryer into final position. Do not crush or kink vent.
Make sure dryer is level.
3. (On gas models) Check to be sure there are no kinks in the
flexible gas line.
Reverse Door Swing
You can change your door swing from a right-side opening to a
left-side opening, if desired.
Remove the door
1. Open the dryer door. Remove the 4 screws that hold the door
hinge on the front panel of the dryer. Loosen, but do not
remove, the screw with the top keyhole opening last (second
from the top).
4,
5,
_®"
J
Remove the 6 screws to release the outer door assembly
from the inner door assembly (see illustration). It is important
that you remove only the 6 indicated screws.
Lift the inner door assembly off of the outer door sseambly.
Unsnap the handle from the outer door assembly, move it to
the other side, and snap in. Set the outer door assembly
aside.
2,
A. Dryer
B. Do not remove
C. Dryer door
Lift and pull forward on the door so that the keyhole clears
the screw head. Remove the door.
Reverse the hinge and hinge bracket
1. Place the inner door, screw head side up, on the work
sur_ac8.
2.
Remove the 4 screws that hold the hinge to the door.
16

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ykehs01p

Tabla de contenido