Descargar Imprimir esta página

Crosley CW-3 Guía De Uso Y Cuidado página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

STNN CLEANER
W_SHi_NSE
TEMP
s_
_
_JN_
S'tA_I_
A_O
TEMP CONTROL
WRjNKLE-FREE
CLOTHES
_,._
TM',_,
These settings feature
Automatic
Temperature
Control:
Saves energy by adding cold water
ATC Warm/Warm
to the hot water from your water
ATC Warm/Cold
heater. Provides optimum
cleaning
at lower temperatures.
May add hot water to the incoming
cold water as the washer fills. This
ATC Cold/Cold
assures that the water will be warm
enough to properly activate detergent.
I Note:
In wash water temperatures
below 60° F,
detergents
do not dissolve well or clean well.
I
Wrinkle-Free
Clothes Cycle
This cycle provides up to 12 minutes of agitation.
Depending
on the load, select either the NormallSIow
or SlowlSIow
wash/spin
speed.
Stain Cleaner Cycle
Stain Cleaner provides approximately
30 minutes of
agitation
and soaking to help remove stubborn
dirt and
stains. For more information
see page 8.
Select Extra Rinse
(if desired)
When the switch is in the On position, an additional
rinse at the end of the Regular/Delicates
cycle is
provided to more completely
remove laundry additives,
suds, perfumes,
etc.
Select Cycle
To select a cycle, push the control dial in and turn it to
the right (clockwise)
until the pointer is at the number
of minutes desired for the wash load.
IMPORTANT:
For optimum
fabric care, the
appropriate
wash and spin speed for the load type
must be selected using the Wash/Spin
Speed knob.
Regular/Delicates
Cycle
Regular/Delicates
cycles share the same portion of the
control dial. For regular fabrics, select the cycle and
turn the Wash/Spin
Speed dial to Normal/Normal.
For
delicate loads, select Slow/Slow.
Pull Control Dial Out to Start
You may stop the washer at any time by simply
pushing the control dial in. Therefore it is possible to
obtain a non-agitated
soak or to shorten, skip or
repeat any part of a cycle. The control dial must be
pushed in (off position) when you change the setting.
Note:
Do not attempt to turn the control dial
counterclockwise.
Damage to the timer will result.

Publicidad

loading