Safety Precautions; Removing The Tool - Sunitec MAB 825 Instrucciones De Manejo

Preparations

Safety precautions

MK tool/industrial arbor
CS Unitec, Inc., 22 Harbor Ave., Norwalk, CT 06850 • Toll-free: 800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 • Email: info@csunitec.com • Website: www.csunitec.com
48
WARNING
Risk of injury!
► Do not use damaged, soiled or worn tools.
► Carry out tool changes only when the machine is switched
off and at a standstill. Remove plug from the mains socket.
► After inserting, check that the tool is engaged securely.
► Only use tools, adapter and accessories that match the
machine.
Mounting the tool/industrial arbor
Before mounting, clean the shank of the tool, adapter or
‹
industrial arbor and the morse taper (3) of the machine.
Push the tool from below into the morse taper (3) of the
‹
machine.
NOTE
► When using tools/adapters with MK2 taper, use MK3:2
adapter sleeve.

Removing the tool

Turn the tool until the ejector pin (F) slips into the opening for
‹
the ejector pin (4).
Prise out the tool with the ejector pin (F) or loosen the tool by
‹
tapping against the ejector pin.
MAB 825/845