Saw Blade Mounting And Dismounting - Metabo HPT C 12LDH Manual De Instrucciones

English
10. How to use the dust bag (Standard accessory)
Dust bag
Duct
Right angle
Fig. 43
CAUTION:

SAW BLADE MOUNTING AND DISMOUNTING

WARNING:
* To prevent an accident or personal injury, always turn off the trigger switch and
* If the bolts are attached or detached using tools other than the 17mm wrench (standard
1. Mounting the saw blade (Fig. 44-a, Fig. 44-b, Fig. 44-c and Fig. 44-d)
(1) Rotate the lower guard (plastic) to the top position.
(2) Use the driver to loosen the 5mm screw fastening the spindle cover and then remove the spindle cover.
(3) Press in spindle lock and loosen 10mm bolt with 17mm wrench (standard accessory).
Since the bolt is left-hand threaded, loosen by turning it to the right as shown in Fig. 44-c.
NOTE:
If the spindle lock cannot be easily pressed in to lock the spindle, turn the 10mm bolt with
17mm wrench (standard accessory) while applying pressure on the spindle lock.
The saw blade spindle is locked when the spindle lock is pressed inward.
(4) Remove the 10mm bolt and washer (B).
(5) Lift the lower guard and mount the saw blade.
WARNING:
22
(1) When the dust bag has become full of sawdust, dust will be blown out of the
dust bag when the saw blade rotates.
Check the dust bag periodically and empty it before it becomes full.
(2) During bevel and compound cutting, attach the dust bag at a right angle to
the base surface as shown in Fig. 43.
Base
Empty the dust bag frequently to prevent the duct and the safety cover from becoming
clogged.
Sawdust will accumulate more quickly than normal during bevel cutting.
disconnect the power plug from the receptacle before removing or installing a saw
blade.
If cutting work is done in a state where the bolt is not suffi ciently tightened, the bolt
can get loose, the blade can come off , and the lower guard can get damaged, resulting
in injuries.
Also, check that the bolts are properly tightened before plugging the power plug into
the receptacle.
accessory), excessive or improperly tightening occurs, resulting in injury.
5mm machine screw
Spindle cover
Fig. 44-a
When mounting the saw blade, confi rm that the rotation indicator mark on the saw
blade and the rotation direction of the gear case (see Fig. 1) are properly matched.
Spindle lock
Fig. 44-b