Saw Blade Mounting And Dismounting - Metabo HPT C 8FSHE Instrucciones De Seguridad Y Manual De Instrucciones

Light fi tting
Light lens
Switch (For laser marker)
(Also serves as light power switch)
Fig. 43
NOTE:
The light will not light up if the laser marker switch is turned off .
13. Cutting easily-deformed materials, such as aluminum sash
Materials such as aluminum sash can easily deform when tightened too much in a vise assembly. This will
cause ineffi cient cutting and possible overload of the motor.
When cutting such materials, use a wood plate to protect the workpiece as shown in Fig. 44. Set the wood
plate near the cutting section.
When cutting aluminum materials, coat the saw blade with cutting oil (non-combustible) to achieve smooth
cutting and a fi ne fi nish.
In addition, in case of a U-shaped workpiece, use the wood plate as shown in Fig. 45 to ensure stability in
the lateral direction, and clamp it near the cutting section of the workpiece and tighten it using both the vise
assembly and the clamp available in the market.
Fence
14. How to use the dust bag (Standard accessory)
Dust bag
Duct
Base
Right angle
Fig. 46
CAUTION:
Empty the dust bag frequently to prevent the duct and the lower guard from becoming
clogged.
Sawdust will accumulate more quickly than normal during bevel cutting.

SAW BLADE MOUNTING AND DISMOUNTING

WARNING:
* To prevent an accident or personal injury, always turn off the trigger switch and
* If the bolts are attached or detached using tools other than the 10mm box wrench
(1) Insert the plug on the main unit into a power socket.
Switch
(2) Turning on the laser marker switch.
(For light)
(3) Set the light switch into the upper position (ON) to light it, and
into the lower position (OFF) to switch it off . (See Fig. 43)
(4) Move the light fi tting to the right and left to adjust the lighting
position.
Vise assembly
Wood plate
Aluminum sash
Wood plate
Fig. 44
(1) When the dust bag has become full of sawdust, dust will be blown out of the
dust bag when the saw blade rotates.
Check the dust bag periodically and empty it before it becomes full.
(2) During bevel and compound cutting, attach the dust bag at a right angle to the
base surface as shown in Fig. 46.
disconnect the power plug from the receptacle before removing or installing a
saw blade.
If cutting work is done in a state where the bolt is not suffi ciently tightened, the
bolt can get loose, the blade can come off , and the lower guard can get damaged,
resulting in injuries.
Also, check that the bolts are properly tightened before plugging the power plug
into the receptacle.
(standard accessory), excessive or improperly tightening occurs, resulting in
injury.
Vise assembly Clamp
Wood plate
Aluminum sash
Wood plate
Fig. 45
English
23