Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Connect to potable water supply
only. A cold water supply is required for automatic
icemaker operation. The water pressure must be
between 40 and 120 psi (275-827 kilopascals).
(on some models)
Ice bin
About the water dispenser.
Spill Shelf
Door ice bin*
1. Open left fresh food door.
2. Pull down latch to release bin door.
3. Using handhold lift ice bucket up and out to clear
locators in bottom of bin.
IceMaker Accesory Kit
If your refrigerator did not came already equipped
with an automatic icemaker, an icemaker accesory
kits is available at extra cost.
IceMaker Installation
This refregerator is ready to receive an Ice Maker
(mod. IM-5A)
(on some models)
Dispenser
(on some models)
Press the glass gently against the dispenser cradle.
The spill shelf is not self-draining. To reduce water spotting, the shelf should be cleaned regularly.
If no water is dispensed when the refrigerator is first installed, there may be air in the water line system. Press th
dispenser arm for at least two minutes to remove trapped air from the water line and to fill the water system. To
flush out impurities in the water line, throw away the first six glassfuls of water.
52
4. To replace the ice bucket, set it on the guide
brackets and push until the ice bucket seats
properly.
5. If bucket cannot be replaced, rotate the Ice
Bucket Fork 1/4 turn clockwise.
Check the back of the refrigerator for the specific
icemaker kit needed for your model.
This installation must be done by a qualified
techniscian.
For technical service see the information
Publicidad
