Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
CHART
_-ROBLEM
CAUSE
L_
of power
o Rear of lawn mower housing
:_oorcut- uneven
=_xcessive
Jibration
_opull
3rass catcher
not filling(if so
_luipped)
Hard to push
or cuttingblade dragging
in heavy grass.
Cutting too much grass,
• Dirty air filter.
, Buildup of grass, leaves,
and trash under mower.
o Too much oil in engine.
° Walking speed too fast.
i,ii
° Wom, bent or loose blade.
• Wheel heights uneven.
° Buildup of grass, leaves
and trashunder mower.
• Worn, bent or loose blade.
° Bent engine crankshaft.
brake ison
when control bar is released,
• Bent engine crankshaft
° Blade adapter broken°
• Blade dragging in grass.
ii,,i ,i
° Cutting height too low.
° Uft on blade worn off.
o Catcher not venting air.
° Grass istoo high or wheel
height istoo low.
,° Rear of lawn mower
jhousing or blade dragging
in grass°
• Grass catcher too full.
° Handle height position not
right foryou.
CORRECTION
° Set to"Higher Cut"
position.
o Set to"Higher Cut"
position.
° Clean/replace air filter.
° Clean underside of mower
housing.
° Check oil level.
° Cut at slowerwalking
.
speed.
° Replace blade. Tighten
blade bolt
° Set all wheels at same
height
° Clean underside of
mower housing.
o Replace blade.Tighten
blade bolt.
° Contact an aLrt,hori.zed
service center.
i
i
i
Depress control bar to
upper handle before
pulling starter rope.
o Contact an authorized
service center.
o Replace blade adapter.
° Move lawn mower to cut
grass or to hard surface
to start engine.
° Raise cutting height
° Replace blade.
° Clean grass catcher°
Raise cutting height.
° Raise rear of lawn mower
housing one (1) setting
higher.
° Empty grass catcher.
° Adjust handle height to
suit.
14
Publicidad
