Theseaccessories wereavailable when
Ibis lawn mower was produced.
They are also
available at most Sears re_l outlets and service centers.
Most Sears stores can also order
repair parts foryou, when you provide the model number of your lawn mower.
Some of _ese
accessotfes
may not apply to your lawn mower°
LAWN MOWER
PERFORMANC
E
...............
CLIPPING DEFLECTOR
FOR REAR DISCHARGE LAWN MOWERS
i
i
i
i
GRASS CATCHERS
FOR
REARDISCHARGE
LAWN MOWERS
MULCHER KITS
,,,i,i,i
l lll
t
GRASS CATCHERS
FOR
SIDE DISCHARGE
LAWN MOWERS
STABILIZER
ill
iii
ill i HH ll/
I
L
GAS CANS
MUFFLERS
LAWN
MOWER
MAINTENANCE
AIR FILTERS
SPARK PLUGS
HH,I ,,,
BELTS
BLADE ADAPTERS
BLADES
WHEELS
ENGINE OtL
Read these instructions
and this manual
in its entirety
before
you attempt
to
assemble
or operate
your new lawn
mower.
"four new lawn mower
has been
assembled
at the factory
with the excep-
tion of those
parts left unassembled
for
shipping
purposes.
All parts such as nuts,
washers,
bolts,
etc., necessary
to com_
ptete the assembly
have been placed
in
the parts bag.
To ensure
safe and proper
operation
of your lawn mower,
all parts
and hardware
you assemble
must be
tightened
securely.
Use the correct
tools
as necessary
to ensure
proper tightness.
TO REMOVE LAWN MOWER FROM
CARTON
• Remove
loose
parts included with
mower.
° Cut down two end comers
of carton
and lay end panel down flat.
• Remove all packing materials except
padding between upper and [ower
handle and padding holding operator
presence control bar to upper handle.
• Roll lawn mower out of carton and
check carton thoroughly for additional
loose parts.
HOW TO SET UP YOUR
LAWN
MOWER
TO UNFOLD HANDLE
IMPORTANT:
Unfold handles carefully
so as not to pinch or damage control
cables.
, Raise handles until lower handle
section locks into place in mowing
position.
• Remove protective padding, raise upper
handle section into place on lower
handle and tighten both handle knobs.