Craftsman 917.387250 Manual Del Operador página 6

The operationof any lawn mowercan
resultin foreign objectsthrowninto the
eyes,whichcan resultin severeeye
damage. Alwayswearsafety glassesor
eye shieldswhile operatingyour lawn
moweror performingany adjustmentsor
repairs. We recommenda wide vision
safetymaskover the spectaclesor
standardsafetyglasses.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED CONTROL
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require an
engine control to be installed on this lawn
mower in order to minimize the risk of
blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
o Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTTING HEIGHT
o Raise wheels for low cut and lower
wheels for high cut,
= Adjust cutting height to suit your
requirements, Medium position is best
for most lawns.
° To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lowerwheels for
high cut
Raise wheels for low
cut
Lever
Plate tab
TO ATTACH GRASS CATCHER
o Close the flip lid. Flip lid must be closed
while operating lawn mower.
o Lift the rear door on the mower housing
and place the grass catcher frame onto
the formed tabs on the rear door hinge
bracket,
° The grass catcher is secured to the lawn
mower housing when the rear door is
lowered onto the grass catcher frame.
CAUTION.* Do not run your lawn mower
without clipping deflector or approved
grass catcher in place. Never attempt to
operate the lawn mower with the rear door
removed or propped open.
door
bracket
Formed
tabs
Grass
catcher
frame
TO EMPTY GRASS CATCHER
° To remove grass catcher, release
operator presence control bar to stop
engine,
o Lift up rear door and remove the grass
catcher by the handle.
° Do not drag the bag when emptying; it
will cause unnecessary wear.
BEFORE STARTING ENGINE
OIL
Your tawn mower is shipped without oil in the
engine.
• Be sure mower is level and area around oil
fill is clean,
• Remove engine oil plug and fill to the full
line on the dipstick.
° Use 20 ozs. of oil. For type and grade of oil
to use, see "ENGINE" in Customer Respon-
sibilities section of this manual.
° Pour oil slowly. Do not over fill,
.1
6
-7