Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
-
Fasten the safety rope and tie to indoor fixture before operating the device.
-
Make sure the battery is fully charged (green light indicator on).
-
Turn the robot on before putting it onto the glass. Once on the glass, make sure it remains
stuck before letting it go.
-
Remove anything on the glass.
Warnings
-
It is recommended to supervise the robot's operating during its first use in order to ensure
it operates properly on the surface you wish to clean.
-
The device should not be unattended while it is connected to a power supply.
-
Always use the safety rope. Ensure its proper positioning and state.
If you wish to clean a surface with specific features and you are not sure if the robot will work
properly, increase the precautions taken and supervise its operation.
Warning
Remember that the safety rope must be always used.
-
Conga WinDroid 880 has been designed to clean every type of window, store window, or
standard, flat, vertical surfaces.
-
For safety reasons, it is recommended not to use the product under the following
circumstances:
-
Do not use the robot in windows or glass without frames.
-
Do not use the robot on curved windows, both concave or convex.
-
Do not use the robot in windows thinner than 3 mm.
-
Do not use the robot in windows with a joint (silicone or rubber) between the frame and
the glass with the following characteristics: the joint has an angle (ɑ) under 45º and its
distance to the frame (lb) is higher than 5 mm; the robot could become loose and fall. If the
joint in your windows have these characteristics, do not use the robot.
3. OPERATION
Important
The robot must always be connected to the power supply in order to operate.
Connectivity
Fig. 2
Plug the power cord to the cable from the power adapter.
Plug the connector to the WinDroid and press the trigger.
Finally, plug the power cord to the electric circuit.
48
Publicidad
