cecotec WINDROID 870 CONNECTED T Manual De Instrucciones página 25

ENGLISH
- The window cleaning robot will automatically stop working and the red-light indicator will
blink.
- Remove the robot from the glass as soon as possible. You can pull carefully from the
safety rope to detach it.
Table cleaning mode
Place the robot on the table and select manual cleaning mode. Then, use the buttons to move
the robot and clean the table manually as desired.
Changing the cleaning cloth Fig. 4
- Assemble the cleaning cloth onto the ring.
- Assemble the ring onto the cleaning wheel and ensure the 6 slots on the ring are well fixed
together to prevent leakage.
Note:
The window cleaning robot can carry out dry and wet cleaning. For wet cleaning, spray some
specific window cleaning agent on the window.
4. CLEANING AND MAINTENANCE
- Use a soft, damp cloth to clean the outside surface of the window cleaning robot.
- The cleaning cloths are washable and reusable.
- Do not immerse the window cleaning robot in water or place it under the tap.
5. TROUBLESHOOTING
Problem
The window cleaning robot does not work and
emits an alarm sound.
The window cleaning robot slips and does not
detect the upper frame while in automatic up/
down mode.
48 CONGA WINDROID 870 CONNECTED T
Cause / Solution
Friction error:
The cleaning cloth is too dirty. Clean it.
There are stickers on the glass, window film,
etc. Remove them.
The window glass has been cleaned too many
times and it is slippery. Remove the window
cleaning robot from the glass or the window
Press the power button and select the "left to
right" cleaning mode to resume cleaning.
The window cleaning robot does not finish
cleaning the entire window surface and stops
in the middle.
The window cleaning robot does not glide
smoothly or moves unsteadily.
After cleaning, the window cleaning robot
leaves marks on the surface of the glass.
The window cleaning robot has stopped
working due to a power failure and is now out
of reach of the user.
The window cleaning robot has stopped
working and the red-light indicator is blinking.
When the window cleaning robot is switched
on, the fan does not turn on and no alarm
sounds.
6. SMARTPHONE APP
This window cleaning robot has a smartphone app which is connected to the robot through
Bluetooth and allows total control over the cleaning process.
Note:
- iOS System requires iOS 7.0 or above versions.
- Android System requires Android 4.3 or above versions.
- Bluetooth 4.3 or above version required.
ENGLISH
Press left and right buttons to continue
cleaning.
The cleaning cloth is too dirty. Clean it or
replace it.
Remove stickers or films on the window.
The screw on the cleaning wheel is loose,
tighten it.
The cloth is too dirty or too wet. Clean it or
replace it.
Carefully pull the safety cord and hold the
window cleaning robot by hand.
Switch off the window cleaning robot by
pressing the power button for 2 seconds.
Carefully pull the safety cord and hold the
window cleaning robot by hand.
Make sure there are no obstacles on the
window or glass. If there are any, remove
them.
Check if there is air leakage caused by a gap or
uneven window frames.
Blue light blinking/red light on/no alarm: low
battery. Charge the window cleaning robot
fully.
Blue light blinking/red light blinking/no alarm:
Hardware error. Contact the official Technical
Support Service of Cecotec.
CONGA WINDROID 870 CONNECTED T 49