cecotec CONGA ROCKSTAR 1700 ADVANCE ERGOWET Manual De Instrucciones página 52

ENGLISH
Charge and display
When the battery percentage is 20 % or below, the device will automatically enter the
-
low consumption mode. It is recommended to charge the device when it reaches this
percentage.
During charging, the charge light indicator will turn on red and the display will show the
-
current charge percentage. When the device is fully charged, the battery indicator will
turn green and the display will show 100%. Fig. 5
You can charge the battery when the battery is installed or not in the device. Connect the
-
adapter and connect the other end to the battery, paying attention to the direction. Once
it is properly connected, the charge light indicator will turn on red and will turn green
once the charge is complete. Fig. 6-7
5. WATER TANK ACCESSORY
- Do not use cleaning agents. Use clean and room temperature water only. Do not use the
vacuum cleaner to vacuum water.
- When the vacuum cleaner is not going to be used for a long time, please remove the
water tank and empty the remaining water. Do not expose it to direct sunlight or to damp
environments.
Mop installation
- Place the mop cloth on the ground with the Velcro facing upwards.
- Align the mop cloth with the velcro strips on the water tank and attach it without
covering the wheels. Fig. 8
Replacing the mop
- Remove the water tank from the device.
- Use your foot to hold the accessory against the ground and pull the vacuum cleaner
upwards until both parts are separated.
- Replace the mop and refill the water tank.
- Install the water tank again, insert the tank in the lower part of the vacuuming brush head
and press until it is fixed.
Water emission
- When using the vacuum cleaner, make sure that the water tank cap is completely closed.
- When you are not using the vacuum cleaner, check that the water emission button and
the cap are closed as the vacuum cleaner may still emit water if the water tank is full.
- To activate the water emission, the water emission push button must be pressed, and to
stop the water emission, the push button must be in the original position, as shown in
figure 9.
52