Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
-
High-pressure hose
-
Spray nozzle
-
3DTurboFlip nozzle
-
360Brush (special for wheel rims)
-
EasyClean brush (special for gaskets)
-
Soap bottle
-
Trigger gun
-
Lance
-
2-Spin brush
-
Anti-impurities filter
-
Nozzle-cleaning needle
-
Instruction manual
3. PRODUCT ASSEMBLY
-
Fit the high-pressure hose (5) to the pressurised water outlet of the pressure washer (6).
-
Attach the trigger gun (7) to the high-pressure hose (5). Before turning on the machine,
make sure the high-pressure hose (5) is completely unwound. The hose (5) should not
become entangled while in use.
-
Install the spray nozzle (10) or the item to be used.
-
Check that the anti-impurities filter (12) is not blocked.
-
Connect the pressure washer to the power supply (8) and water supply (3).
Note
It is very important to let air out of the trigger gun before using the pressure washer. Press
the trigger to let all the trapped air out of the unit and the high-pressure hose. Hold down the
trigger until a continuous water jet comes out of the nozzle. This process may take 2 minutes.
4. OPERATION
Setting the water pressure
The angle of the water jet can be set with the spray nozzle by turning the tip. This will cause
the jet to vary from approximately 0° (narrow high-impact water jet) to 60° (wide-spray water
jet). Fig. 2
This device has 3 modes:
72
HYDROBOOST 2000 CAR&GARDEN PRO
Publicidad
