cecotec HYDROBOOST 2500 HOME&CAR Manual De Instrucciones página 69

- Replace the cover.
- Disassemble the wand from the gun.
- Install the soap bottle in the gun. Fig. 10
- Apply soap in a manner that it covers all the surface to be cleaned. Apply it from bottom to
top to avoid soap from falling down and staining the surface.
- Leave the soap to act on the surface for several minutes. However, in particularly soiled
areas, use a brush to gently scrub. Do not allow soap to dry on the surface.
-
Remove the soap bottle from the gun and replace it with the wand and spray nozzle or
accessory to be used.
- Rinse the soap from the surface.
Note
Rinse the soap bottle with clean water after every use.
Final rinse
Start the final rinse from bottom to top. Make sure that the surface is well rinsed and that all
dirt has been removed.
Turning off
- Make sure there is no detergent in the system.
- Turn off the motor. Turn off the water supply.
- Once the product and the water supply have been turned off, press the trigger to
depressurise the device.
- After each use, wipe the surface of the pressure washer with a clean, damp cloth.
Warning
- Do not turn off the water supply until the motor has been switched off, as this could cause
serious damage to the pump and motor.
- Do not remove the high pressure hose from the machine while the system is being
pressurised. To depressurise the device, turn off the motor and water supply and press the
trigger 2 or 3 times.
Tips for extending the product shelf life
-
Do not use the product without water.
- Do not use the product with hot water.
- Never use the unit for more than 1 minute without spraying water.
HYDROBOOST 2500 HOME&CAR
ENGLISH
69