RIDGID R4520 Manual Del Operador página 24

ASSEMBLY
TO INSTALL THE ANTI-KICKBACK PAWLS AND
BLADE GUARD
See Figures 24 - 26.
WARNING:
Always install the blade guard and anti-kickback
pawls onto the riving knife in the "up" position
to provide proper blade coverage. Installing the
guarding components onto the riving knife in any
other position will prevent them from working
as designed, which could increase the risk of
serious personal injury.
WARNING:
Replace dull or damaged anti-kickback pawls.
Dull or damaged pawls may not stop a kickback
increasing the risk of serious personal injury.
NOTE: Anti-kickback pawls should only be installed for
through cuts.
 Unplug the saw.
 Raise the blade by unlocking the height adjusting
handwheel and turning it clockwise.
 Place riving knife in "up" position.
 Reinstall the throat plate.
To install anti-kickback pawls:
 Press and hold the button on the right side of the anti-
kickback pawls.
 Align the slot in the pawls over the rear notch in the riving
knife.
 Push the pawl handle down snapping it into place and
release the button.
NOTE: Pull on the handle to make sure pawls are securely
locked.
To install blade guard:
 Lift the guard lever up to unlock.
 With the front of the blade guard raised and the guard
lever unlocked, lower the back of the guard into the middle
slot of the riving knife. Push the front of the guard down
until the bar inside the guard is parallel to the table (see
figure 26). If the bar is not parallel to the table, the riving
knife is not in the "up" position.
 Lock the guard in place by pushing the guard lever down.
 The blade guard side barriers may be lifted, then
positioned out of the way without being removed for
easier measurement.
PAWL
HANDLE
ANTI-KICKBACK
PAWLS
BLADE
GUARD
24 - English
BUTTON
TO
LOCK
RIVING
KNIFE
CORRECT
INCORRECT
Fig. 24
GUARD
LEVER
Fig. 25
Fig. 26