cecotec HIDROBOOST 3200 INDUCTION PRO Manual De Instrucciones página 12

Do not remove the high-pressure hose from the machine while
the system is being pressurised. To depressurise the device,
turn it off, stop the water supply, and then press the trigger 2
or 3 times.
Do not activate the trigger locking system while the machine is
in operation.
Do not operate the appliance unless all parts are properly
connected to the main body (handle, gun, nozzle, etc.).
Make sure to turn on the water supply before turning on the
pressure washer. Running the pump without water can cause
serious damage to the pump.
Do not use the pressure washer if any parts are missing or
damaged. Check the condition of the product regularly and
repair or replace damaged or worn parts immediately.
Use only original spare parts supplied or recommended by
Cecotec to ensure safe operation.
Use only the nozzle included with the product.
Do not leave the high-pressure hose unattended while the
device is operating.
Hold the high-pressure hose and gun firmly when switching on
and while using the machine.
Do not leave the unit running with the trigger released for more
than one minute, as this could damage the pump.
This device is not designed to pump hot water. Do not connect
to a hot water supply as this will significantly reduce the shelf
life of the pump.
H I D R O B O O S T 3200 INDUCTION PRO
12
This symbol means that this device is not
suitable to be connected to drinking water
sources.
Make sure the water inlet pressure is between
0.01 MPa and 0.4 MPa and that the inlet hose
is at least 5 metres long.