cecotec CONGA 2299 INERTIAL X-TREME Manual De Instrucciones página 56

ENGLISH
3 Fan error
4 Main-brush fault
Other possible scenarios:
Problem
The robot vacuum cleaner
does not activate.
The robot vacuum cleaner
suddenly stops working.
The programming function
does not work.
Suction power level is very
low.
The robot vacuum cleaner
does not charge.
The robot vacuum cleaner
does not return to the
charging base.
56
CONGA 2299 INERTIAL X-TREME
Clean the dust or objects that may be blocking the air inlet
channel.
Check if the main brush is blocked or tangled and clean it.
Solution
Make sure the battery is fully charged.
If the problem persists, reset the robot vacuum cleaner by pressing
the RESET button.
Check if the robot vacuum cleaner is trapped or stuck with any
obstacle.
Check the battery level.
If the problem persists, turn the robot off and then on again. If the
issue persists, press the RESET button.
Check if the robot vacuum cleaner battery is too low to turn on.
Check if there are obstructions blocking the air inlet.
Empty the tank.
Clean the filters with a vacuum cleaner or a self-cleaning brush.
Check if the filters are wet.
Dry the filters in a natural way before using them. Make sure they
are completely dry. If there are any moisture remains, they could
reach the motor and damage the robot vacuum cleaner.
Check if the charging base indicators are on. Otherwise, contact the
official Technical Support Service of Cecotec.
Clean the charging terminals with a clean, dry cloth.
Check if the robot vacuum cleaner beeps when it gets to the
charging base. Contact the official Technical Support Service of
Cecotec.
Remove the objects 1 metre on the left and right, and 2 metres in
front of the charging base.
The robot vacuum cleaner will return to the charging base faster
when it is near it. When it is far, it will take more time to identify it.
Clean the charging terminals.