Labor pro life LASER & GO W025 Manual De Instrucciones página 9

PROBLEM DESCRIPTION
The appliance and the adapter heat up
during use.
During use, the display shows the cooling
fan rotating.
The flash figure flashes but the device
does not emit light pulses when the
button is pressed.
It is not possible to increase or reduce the
pulse intensity level.
There is an unpleasant smell during use.
During the treatment cycle, the skin
is more sensitive than usual or there is
intense pain.
The result is not as expected.
POSSIBLE CAUSES
This is normal.
Overheating protection
activated.
The appliance must be restarted.
The appliance must be restarted.
It is likely that the optical filter is dirty.
There are probably a few hairs left on
the surface, which burn off causing
unpleasant odours.
The intensity level chosen may be too
high.
It is likely that not all of the hair was
shaved before the treatment.
The optical filter may be damaged.
You are probably using the appliance in
an area that is too sensitive.
Skin colour may not be suitable for IPL
pulsed light treatment.
The intensity level used is probably too
low.
It is likely that light pulses have not been
emitted evenly across all areas of the
skin.
The hairs may be too light.
It is likely that the treatment was carried
out with little frequency.
The reaction to IPL therapy may be slow.
9
No intervention is required.
has been
No intervention is required.
Switch the appliance off and on again.
Switch the appliance off and on again.
Clean the filter thoroughly with a dry,
lint-free cloth.
Shave the
proceeding with the treatment.
Make sure the appropriate intensity
level is selected. Carry out a patch test
to make sure the skin responds properly.
Shave the
proceeding with the treatment.
If the optical filter is broken/cracked/
damaged, do not use the appliance.
Please contact the customer service
centre.
Do not use in the area around the eyes
or eyebrows, on nipples, genitals or in the
anal area, nostrils and ears.
If your skin is type V or VI, naturally dark or
tanned, do not use the device.
Select and use a higher level during the
next treatment.
Emit the light pulses proceeding in an
orderly manner, trying to cover the whole
area to be treated (and avoiding the
overlapping of pulses).
If the hair is blonde, red or white, the
treatment will not be effective.
To successfully remove all hair, we
recommend following the suggested
treatment cycle.
Use the device for at least 6 months
continuously because hair regrowth will
decrease during this time.
SOLUTIONS
skin carefully before
skin carefully before