Publicidad
Idiomas disponibles
Idiomas disponibles
Introduction
1. Disc installation location
2. Handle screw
3. Disc spindle lock button
4. On/off button
5. Lock button of On/Off
button in the On position
6. Battery level and operating
mode selection
7. Battery compartment
Turn on and Turn off
1. Press and hold the power button on the bottom of the grinder to turn it on.
If you want to lock the button in the On position, press the round button
located above the On/Off button. Press the power button again to unlock
it.
2. Release the power button to stop the grinder. Careful! After releasing the
button, the disc continues to rotate for 2-3 seconds.
Usage instructions
1. Mount the handle by screwing it into the dedicated threaded hole on the
left or right side of the grinder.
2. Press the black round button on the top of the grinder to fix the spindle on
which you are going to install the disc.
3. Insert the flange first, then the disk and finally the nut.
4. Tighten the nut well with the wrench included in the package.
5. To remove the disk, perform the installation operations in reverse order.
6. Press the MODE button to choose the rotation speed. There are a
maximum of 3 speed steps. When all 3 LEDs 1, 2 and 3 are lit, the grinder
operates at maximum speed.
7. Maintain a firm grip on the electric grinder and position your body and
arms to counteract kickback forces.
7
User manual
Publicidad
