monzana Lilly MZDLLs Manual Del Usuario página 10

Note: The battery is designed to store settings if there is a brief disconnection from the mains.
3. Touch the " " button below the display to switch on the light with a brightness level of 10
%. By touching the button again you can increase the brightness from 10 % to 40 % and 100
%, and turn the light off again. (diagram C).
4. Adjusting the position of the lamp arm and head: Hold the lamp base steady when adjusting
the lamp arm and lamp head. The lamp arm can be adjusted up to approx. 150° (diagram
D). Excessive movement will damage the joint mechanism.
5. Replacing the battery: Please only replace the CR2032 battery with a battery of the same type
(diagram E).
OPERATION
DISPLAY
CONTROL BUTTONS ON THE BACK OF THE LAMP
SETTING THE DATE AND TIME:
1. In TIME MODE, press the "S" button to make the hour display flash. Now press the "
on the lamp base to decrease the hour or the "
button again to confirm the hour; the minute display will now flash.
2. Repeat the above steps to set minutes -> year -> month. Then return to TIME MODE.
3. In SETTING MODE, press the "M" button to exit, this will also happen automatically after one
minute if the button is not pressed.
4. In TIME MODE, press the "
SETTING SNOOZE MODE AND ALARM CLOCK:
1. In TIME MODE, press the "M" button to enter ALARM MODE. The time mode symbol "
will disappear and the alarm symbol
" " will appear.
1 Temperature display
2 Alarm clock mode
3 Time mode
4 12/24-hour display
5 Date (month/day)
6 Temperature
Fahrenheit)
7 Snooze mode
8 Time (hour)
9 Time (minutes)
10 Date (day of the week)
Up
Down
S
Set
M
Mode
" button to increase the hour. Press the "S"
" button to change the time from 12-hour to 24-hour display.
10
unit (degrees Celsius/degrees
www.DEUBAXXL.de
" button
"