Progress Lighting AirPro Tarsus P250102-009-CS Manual De Instalación página 11

Installing the Light Kit
Pan/Light Kit Fitter
Assembly/ Glass Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing the light kit.
1. Loosen but do not remove two of three
mounting screws from the fan motor
assembly; Remove one mounting screw.
(Figure 14)
2. Push the light kit pan up to the fan motor
assembly so that the two loosened screw
heads fit into the keyhole slots. Turn the
light kit pan clockwise, tightened the
screws. Re-install the screw that was
removed in step 1 and tighten firmly.
(Figure 14)
3. Remove one screw from the light kit pan
and loosen, but do not remove the other
two screws. Connect the wires from the
light kit fitter assembly to the wires from
the fan motor assembly by connecting the
molded adaptor plugs together. Carefully
tuck all wires and splices into the switch
cap. (Figure 15)
4. Push the light kit fitter assembly up so
that the two loosened screw heads fit into
the keyhole slots. Turn the light kit fitter
assembly clockwise, tighten the screws. Re-
install the screw that was removed in step 3
and tighten firmly. (Figure 15)
5. Place the glass shade into the light kit pan,
aligning the three flat areas on the top of the
glass shade with the three raised dimples
in the light kit pan. Turn the glass shade
clockwise until it stops. (Figure 16)
PERIODICALLY CHECK THE GLASS SHADE IS
SEATED FULLY CLOCKWISE IN THE LIGHT KIT
PAN ASSEMBLY.
Screws
LK pan
White
Molded
adaptor plugs
White
Motor Assembly
Flat area
LK Pan
Figure 14
Molded
adaptor plugs
Screws
Light kit fitter
assembly
Figure 15
LK pan
Raised dimples
Glass shade
Figure 16
8.