Progress Lighting AirPro Tarsus P250102-009-CS Manual De Instalación página 8

Installing Fan to
the Electrical Box
WHEN USING THE STANDARD BALL/DOWNROD
MOUNTING, THE TAB IN THE RING AT THE
BOTTOM OF THE MOUNTING BRACKET MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
1. Pass the 120-volt supply wires through the
center hole in the ceiling mounting bracket
as shown in Figure 8.
2. Install the ceiling mounting bracket on the
electrical box by using the mounting screws
provided with the electrical box. Note that
the flat side of the mounting bracket is
toward the electrical box. (Figure 8)
3. Tighten the two screws on the electrical box
securely.
4. Carefully lift the fan assembly up to the
ceiling mounting bracket. Make sure the tab
on the mounting bracket is properly seated
in the groove in the hanger ball. (Figure 9)
5. Making the Electrical Connections
electrical box
Ceiling
mounting
bracket
Hook
Mounting screws
(supplied with
120V wires
electrical box)
Standard mounting
Installing the
Receiver into the
UL Listed
Mounting Bracket
1. Position the house supply wires to one side
of the slide-on mounting bracket; position
Washers
the fan wires to the opposite side.
2. Insert the narrow end of the receiver (as
shown, flat side toward ceiling) into the
slide-on mounting bracket until it rests on
Figure 8
top of the ball/downrod assembly. (Figure
10)
Figure 9
Figure 10