Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Removing the Battery
1. Ensure the sprayer is on a stable surface and
turned OFF.
2. Open the battery compartment by releasing
the metallic latch attached to the side door, and
swing the door open sidewards.
3. Press the battery release button (2) and remove
the battery from the compartment.
4. Close the door and ensure that the metallic door
latch (1) is engaged.
Battery Life Indicator
1. When the battery is installed, you can check the
battery life. This feature is active whether the
device is turned ON or OFF. A red indicator light
will illuminate to the left of the rocker switch for
the corresponding High/Low setting when it is
ON.
2. The power interface has a rocker-style switch (1),
power ON indicator lights (2), a battery indicator
push button (3), and indicator lights (4) as shown
in Fig 11.
3. Press and hold the battery indicator button (3) to
illuminate indicator lights (4).
4. Battery indicator lights:
a. Three white lights indicate:100%–75%.
b. Two white lights indicate: 74%–51%.
c. One white light indicates: 50%–25%.
d. One yellow light indicates: <25%.
NOTE: The LED on the battery may still show a
remaining charge even though the sprayer does not
operate.
Fig. 11
2
14
Spraying
WARNING: RISK OF PERSONAL INJURY AND/OR
PROPERTY DAMAGE DUE TO UNINTENDED SPRAYING
OF CHEMICALS. Ensure the shut-off lever is released
before powering ON the sprayer. Once powered ON,
the pump will pressurize the system and spray if shut-
off lever is depressed.
NOTICE: RISK OF PROPERTY DAMAGE. Only spray
when the air is calm (no wind or air movement) to
prevent chemical spray from drifting onto non-
targeted surfaces.
1. Switch the Power button (1) to ON position
to turn the sprayer ON. If the sprayer has not
been used recently, you may hear a low, audible
sound. This indicates the pump has turned on
and is building pressure in the system.
NOTE: If the sprayer was used recently, and still has
pressure in the system, the pump may not turn on until
the shut-off lever (2) is squeezed.
2. Aim the wand in the desired direction of spraying
and squeeze the shut-off lever (2).
Fig. 12
2
1
3. For continuous spraying, squeeze the shut-off
lever (2) and rotate the lock (3) clockwise to hold
the shut-off lever (2) in the depressed position.
4. Unlock by rotating counterclockwise, if needed,
and release the shut-off lever (2) to stop spraying.
4
5. To turn off the sprayer, switch the power button
to the OFF position (1).
6. Always remove any chemicals, and clean the
3
sprayer when finished. See the Cleaning and
Storage sections of this manual.
1
3
Publicidad
