Publicidad
Idiomas disponibles
Idiomas disponibles
Installing and Removing the Battery Pack
(Fig. 3)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack into the tool handle, align the rails inside the
tool's handle with the battery pack and slide the battery pack firmly
into the handle until you hear the lock snap into place.
To remove the battery pack from the tool, press the release buttons
(A) and firmly pull the battery pack out of the tool handle. Insert it into
the charger as described in the charger section of this manual.
FIG. 3
A
Switch (Fig. 2)
DC800
Pressing the BOTTOM part of the rocker switch (B) runs the
tool in forward (right-hand thread) direction. Pressing the TOP
of the switch reverses motor direction. This allows "rocking"
fasteners to break them loose.
Variable Speed Trigger Switch (Fig. 2)
DC810, DC815
To turn the tool on, squeeze the trigger switch (C). To turn the tool
off, release the trigger switch. Your tool is equipped with a brake.
The anvil will stop as soon as the trigger switch is fully released. The
variable speed switch enables you to select the best speed for a
particular application. The more you squeeze the trigger, the faster the
tool will operate. Use lower speeds for starting screws or fasteners.
For maximum tool life, use variable speed only for starting fasteners.
NOTE: Continuous use in variable speed range is not recommended.
It may damage the switch and should be avoided.
Forward/Reverse Control Button (Fig. 2)
DC810, DC815
A forward/reverse control button (D) determines the direction of the
tool and also serves as a lock off button.
To select forward rotation, release the trigger switch and depress
the forward/reverse control button on the right side of the tool.
To select reverse, depress the forward/reverse control button on
the left side of the tool. The center position of the control button locks
the tool in the off position. When changing the position of the control
button, be sure the trigger is released.
NOTE: The first time the tool is run after changing the direction of
rotation, you may hear a click on start up. This is normal and does
not indicate a problem.
10
Publicidad
