Tennant IPC Kosmic-H Manual De Instrucciones página 30

A A
FIG. 11
USING THE CLEANER
CONTROL PANEL
A - On/off switch
B - Burner switch
C - Power indicator light.
D - Diesel level indicator light.
E - Fault indicator light.
F - Fault Maintenance light.
STARTING THE CLEANER
1) Turn on the water supply tap (fig. 9A).
2) Connect the water cleaner to the mains electricity
supply by plugging the plug into the socket.
3) Start the cleaner by turning the selector switch to
pos. "I" (fig. 11A).
Warning
The high pressure water jet generates a reaction for-
ce in the lance. Keep a firm grip on the lance handle.
4) Press the trigger on the gun and begin washing.
5) To operate the water cleaner with hot water, turn
the temperature regulator to the recommended wa-
shing values. (fig. 11B).
Warning
In water cleaners with the "Total Stop" system, the
motor starts and stops when the lever on the lance
handle is actioned or released.
Danger
Do not block the handle lever in the delivery position.
WARNING SIGNALS AND FAULTS DISPLAYED.
Indicator light C): Power is on when the indicator is
permanently alight (switch "A" in position I); when the
indicator light blinks, the appliance is in "TSI" status.
Indicator light D): Diesel level; when alight, indi-
cates that the level is too low. The appliance shuts
down.
Indicator light E): Indicator permanently alight: 250
h scheduled maintenance due. Once the required
28
B B
C
D
E
F
EN - english
FIG. 12
maintenance has been carried out by an IPC-appro-
ved Service Centre, the light will extinguish.
Indicator light F): Warns when faults occur
- 2 blinks: Micro-leak alarm
- 3 blinks: alarm - no water.
- 4 blinks: alarm - motor thermal protector activated.
- 5 blinks: alarm - safety thermostat activated.
IMPORTANT!
To eliminate any impurities or air bubbles from the
water circuit we advise starting the cleaner for the
first time without the lance and letting the water run
out for a few seconds.
Impurities could block the nozzle and cause malfun-
ction (Fig. 12)
Warning
N.B. To reset the indicators, rotate the main swi-
tch "A" to the "0" position and then to the "I"
position (fig.11).
IMPORTANT:
For maintenance and/or repairs, use only ori-
ginal spare parts which offer the greatest cha-
racteristics of quality and reliability. Failure to
use original spare parts frees the manufactu-
rer from all responsibility.
USING THE ACCESSORIES.
The high pressure washer has a nozzle with a flat
angle jet for cleaning large surfaces.
ROTARY HEAD (optional accessory)
The high pressure washer can be fitted with a head
with rotary nozzle to clean the most stubborn dirt.
Danger:
Aim the jet from a certain distance to avoid damage
caused by the high pressure.
Do not aim the jet at people, animals or electrical
sockets.