Trumpf TruTool F 125 Manual Del Usuario página 11

3 Operation
To operate the power tool, see:
– Adjusting the hammer opening
[} 158].
A
– Switching on and off
– Locking a seam
– Adjusting the bottom hammer
[} 160].
E
3.1 Locking a seam
For greater sheet thicknesses, the seam
must be locked in several steps, see Locking
a seam [} 158].
C
The hammer opening must be readjusted af-
ter each step, see Adjusting the hammer
opening [} 158].
A
5 Troubleshooting
Problem
Electric tool is sluggish.
Power tool does not switch
on.
5.1 Replace the power cable
The power cable may only be re-
placed by the manufacturer or its contract
workshops to prevent safety hazards.
For TRUMPF service addresses, see:
www.trumpf.com
5.2 Replace carbon brushes
If the carbon brushes are worn, the
motor stops.
Have carbon brushes checked by a tech-
u
nician and replaced.
[} 158].
B
[} 158].
C
Cause
Plastic buffers are worn.
Power cable is defective.
Carbon brushes are worn.
Translation of the original operator's manual
4 Consumables and
accessories
4.1 Tool selection
For notes about the selection of the correct
tool, order specifications for wearing parts
and consumables, and accessories and
spare parts lists, see:
www.trumpf.com
F 125
(2A1)
Remedy
Replacing the plastic buffer
u
[} 159].
D
Replace the power
u
cable [} 11].
u Replace carbon
brushes [} 11].
6 Repair
Service, changing, and inspection of power
tools must be done properly.
The safety regulations according to DIN
VDE, CEE, AFNOR, and other regulations
valid in individual countries must be adhered
to.
If a connection line must be replaced, have
this repair done by the manufacturer or its
representative to avoid safety hazards.
EN
11