Publicidad
Idiomas disponibles
Idiomas disponibles
[o]d =i--_,2iii [o_
_WARNING:
To reduce the risk of
serious personal injury, read, understand
and follow all important safety warnings
and instructions prior to using this toot.
_i, WARNING: To avoid electrical shock
under no circumstances
should this
product be used near water.
_i, WARNING: Always unplug product from
power supply before any of the following
operations.
Carton Contents:
6 - Sanding Sheets (2) each 80, 120
and 240 Grits
4 - Pads (2) Abrasive, (1) Steel Wool
and (1) Foam Polishing
12 - Patented Reversible Tips (4) each
80, 120 and 240 Grits
8 - Pad Tips, (4) Abrasive, (2) Steel
Wool and (2) Foam Polishing
3 - Finger Detail Sanding Tips 180 Grit
1 Finger Detail Attachment
Kit Box
O
OnO.
f
Detail Sanding
Your toot is equipped with a Hook and
Loop teardrop base which allows you to
use it on both large flat surfaces and in
tight spots or corners.
Fitting Sanding
Sheets
or Pads
( Fig. 2)
• Detach and save the two diamond-
shaped tips from the sanding sheet or pad.
• Hold the toot with the sanding base
facing upwards.
• Place the sanding sheet or pad onto the
sanding base.
• The diamond-shaped
tip can be reversed
or replaced when worn.
• When the front part of the tip is worn,
detach it from the sheet, reverse it and
press it onto the sanding base again.
• When the whole tip is worn, remove it
from the sanding base and fit a new tip.
Extra Tips
iiiii iiliill!!!iiiiiiiiiiii:iiiiiii!!ii!!iili/li!ii!,i!iiii ii
Y ,,,,
..........
Tip of the Sanding
Base ( Fig. 3)
When the tip of the teardrop sanding
base becomes worn, it can be reversed
or replaced.
• Remove the screw.
• Reverse or replace the base tip.
• Fit and tighten the screw.
SWITCH
To turn the toot ON, hold it as shown in
Figure1 and push the portion of the switch
marked "1".To turn the toot OFF, push the
portion of the switch marked "O".
USE
Grasp product as shown in Figure 1 and
turn it on. Move it in tong sweeping strokes
across the surface, letting it do the work.
/
Light pressure is all that is required for
Base Tip
sanding, polishing or scrubbing.
Excessive pressure wilt slow the tool and
produce inferior results. Check your work
often, product is capable of removing
.... JJJ
material rapidly.
Sandpaper
Rotate 180 °
Base
/
Publicidad
