Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
-
Press the start/pause button (5) to
start cooking (if the start/pause
button or any other button is not
pressed within 25 seconds, the
appliance will start cooking
according to the displayed
temperature and time).
-
During cooking you can change the
time and temperature.
-
If you wish to pause cooking, press
the start/pause button (5).
-
If you wish to stop the appliance
completely, press the start/pause
button (5) for 5 seconds. The display
will go off and the appliance will
enter standby mode.
MENU MODE
-
Once the ingredients are in the
basket and the fryer is plugged in,
press the menu selector (7) to select
the desired menu.
-
You can change the temperature
and time of the menus. Simply
follow the steps explained in the
manual mode.
-
Press the start/pause button (5) to
start cooking.
-
During cooking you can change the
time and temperature.
-
If you wish to pause cooking, press
the start/pause button (5).
-
If you wish to stop the appliance
completely, press the start/pause
button (5) for 5 seconds. The display
will go off and the appliance will
enter standby mode.
NOTES
-
At the end of cooking, the appliance
beeps 5 times. The appliance goes
into standby mode.
-
When the fryer stops, remove the
basket and the food inside. Place
the basket on a heat-resistant
surface.
-
To increase/decrease the
temperature or time quickly, press
and hold the +/- buttons.
During the cooking time, the digital
-
display will show the set minutes
and the set temperature.
For a crispier result add a little oil to
-
the recipe.
-
IMPORTANT: Do not turn the
baskets upside down as the
remaining oil on the bottom may fall
out.
DELAY FUNCTION
-
The "delay" function is used to
program the start of cooking at a
specific time.
-
Once the food is in the basket and you
have selected manual mode or menu
mode, you can program the start of
cooking.
-
To do this, press the button (6). You
can select to start cooking in 10 min
or up to 180 min.
-
Press the start/pause button (5). The
appliance will start cooking after
these minutes have elapsed.
-
Only the buttons (5) and (6) will be lit
on the display and the remaining
minutes will be shown.
-
To cancel the programming, press the
start/pause button (5) again.
AFTER USE OF THE DEVICE HAS
BEEN COMPLETED
-
Unplug the unit from the mains.
-
Clean the unit as described in the
cleaning section.
Cleaning
-
Unplug the unit from the mains and
allow it to cool down before
cleaning.
-
Clean the unit with a damp cloth
soaked in a few drops of detergent
and then wipe it dry.
-
Do not use solvents, or products
with an acid or basic pH factor such
as bleach, or abrasive products to
clean the appliance.
EN
Publicidad
