OPERATION
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
The power scrubber can be used to clean exterior and
interior surfaces.
This product is not for commercial use.
INSTALLING/REMOVING BATTERY PACK
See Figures 1 - 2, page 10.
NOTE: HART battery packs larger than 4.0Ah. will not fit
inside this product.
Unlock the tabs and open the battery cover.
Insert the battery pack into the product as shown.
Make sure the latch on the battery pack snaps into place
and the battery pack is secured in the product before
beginning operation.
Close the battery cover and lock the tabs.
Depress the latch and pull to release and remove the
battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
WARNING:
Do not operate the scrubber with the battery door open.
An open door could expose the battery and battery
compartment to wet conditions which could increase
the risk of electric shock.
SELECTING A BRUSH ACCESSORY
Selecting the correct type of brush accessory is important
in order to obtain the best performance from the power
scrubber. Select the brush accessory based on the appli-
cation and on the surface you wish to clean. Selecting the
right brush accessory will help you clean more efficiently
and protect the surface being cleaned. To reduce the risk of
property damage, always test the brush in an inconspicuous
area of a surface before beginning a project.
NOTE: A brush accessory with medium bristles is included
with your power scrubber. Brush accessories with hard
and soft bristles can be purchased where you bought this
product.
BRUSH ACCESSORY SELECTION GUIDE
Soft Bristle (White)
Light Duty Cleaning
Medium Bristle (Blue)
General Purpose Cleaning
Hard Bristle (Black)
Heavy Duty Cleaning
INSTALLING/REMOVING BRUSH ACCESSORIES
See Figure 3, page 10.
Remove the battery pack.
Pull the quick-connect collar out and hold it in place.
NOTE: The quick-connect collar is spring loaded and will
automatically retract when released.
Insert the brush accessory into the power scrubber.
Release the collar so that the brush accessory is secured
properly. Check to see that the brush is secure.
Remove the brush accessory by holding the brush then
pulling the quick-connect collar out.
7 – English