Publicidad
Idiomas disponibles
Idiomas disponibles
! ATTENTION: run the recharge cycle exactly as
end of the cycle, detach the connectors.
-
Disconnect the battery pack connector from the
electrical system of the machine.
-
Connect the battery pack connector to the
connector of the battery charger.
-
Plug the battery charger into the mains power
socket.
-
Start the recharge cycle.
Battery: removal
!
following precautions:
Contact with the skin can cause irritation; wash
with soap and water.
Inhalation of vapours can cause irritation to the
airways; stay out in the open air and consult
a doctor.
Contact with eyes can cause irritation, wash
eyes immediately and thoroughly
with water for at least 15 minutes; consult a
doctor.
! DANGER: When removing the batteries, the
skilled technician must wear the Personal
Protective Equipment (gloves, eyewear,
overalls, etc.) needed to limit the risk of
accidents; remove the ignition key from the
control panel before proceeding with the
removal operation, keep away from naked
do not cause sparks and do not smoke.
! ATTENTION: before carrying out the operations
apply the parking brake.
-
Disconnect the terminals of the battery cables
from the battery poles.
-
to the base of the machine.
-
Lift the batteries from the compartment using
suitable handling equipment.
Replacement of Brushes and Pads
! DANGER: during installation, the operator
must wear personal protective equipment
(gloves, eyewear, overalls, etc.) needed to limit
the risk of accidents.
The machine can be equipped with disc brushes, roller
brushes and pads. Check the brushes and the pads every
day to make certain there are no wires, threads or strings
entangled around the brush or the drive board. Check for
wear on the brushes and the pads.
Replace the brushes when the bristles are worn down to
the point of exposing the red indicator.
Wash the brushes and pads with soap and water following
use, and hang them up to dry.
EN
32
Publicidad
