Tennant T1581 Manual De Instrucciones página 33

Replacing the squeegee blades
! ATTENTION: before carrying out the operations
apply the parking brake.
! DANGER: during installation, the operator
must wear personal protective equipment
(gloves, eyewear, overalls, etc.) needed to limit
the risk of accidents.
time, and the constant wiping action, the edge of the blade
blade is required.
- Remove the vacuum hose from the squeegee.
- Remove the squeegee from its mount by
unscrewing the two knobs completely.
- Unscrew the nuts.
- Remove the blade retainers.
- Remove the blade.
-
that all four edges in turn are placed in contact
likewise for the front blade, in this case until the
two edges are worn out; alternatively, replace with
the squeegee.
-
- Tighten the nuts.
- Replace the squeegee on its mount.
Side brushes wear adjustment (Cylindrical
Brush Model).
! ATTENTION: before carrying out the operations
apply the parking brake.
! DANGER: during installation, the operator
must wear personal protective equipment
(gloves, eyewear, overalls, etc.) needed to limit
the risk of accidents.
due to excessive wear, they can be adjusted as follows:
- Move the side brush to the working position.
- Loosen the adjustment screws on the brush motor
support.
- Position the brush by hand, as required.
- Tighten the adjustment screws.
Machine Jacking
! ATTENTION: before carrying out the operations
apply the parking brake.
! DANGER: when lifting the machine, use
suitable equipment with a load capacity
! DANGER: the machine must be lifted only
from the points indicated below.
! DANGER: empty the dirty water and detergent
solution tanks before lifting the machine.
EN 33