Teka HLB P Serie Guia Del Usuario página 30

2. Gently pour 200 ml of water into the bottom
of the oven cavity.
INFoRMaTIoN
For best results, add a teaspoon of mild
washing up detergent to the glass of water
before pouring onto the cloth.
3. Turn the control dial to the
4. You will hear a beep indicating that the Teka
Hydroclean cycle has started. The
®
bol will flash slowly and the time remaining to
complete the cycle will appear on the display.
IMpoRTaNT
The duration of this cycle cannot be changed.
To stop the cycle before it is finished, turn
the control dial to the
pyrolytic self-cleaning function
Function available in pyrolytic models HLB P.
WaRNING
Before setting the pyrolytic cleaning cycle,
carefully read the safety instructions, which
30
User's Guide
position.
sym-
position.
5. When the cycle is finished, the oven will turn
itself off, an alarm will sound and the
symbol will flash quickly.
IMpoRTaNT
Do not open the oven door until the Hydro-
clean function is complete.
®
The cooling cycle is necessary for the func-
tion to work properly.
6. Touch any sensor with your fingertip to stop
the alarm and turn off the
7. Turn the control dial to the
8. Any traces of dirt and excess water can now
be removed from the oven with the damp
cloth.
The Hydroclean function takes place at a low
®
temperature. However, cooling times can vary
depending on the room temperature.
WaRNING
Before touching the inside surface of the
oven, make sure that it has cooled properly.
If a deeper clean is required after using the Hy-
droclean function, use neutral detergents and
®
non-abrasive sponges.
you will find at the start of the Installation and
Maintenance guide.
This function allows you to carry out a pyrolyt-
ic cleaning cycle during which, due to the high
symbol.
position.