Pioneer F-223L Manual De Instrucciones página 6

OPERATIONS
Listening to FM or AM broadcasts.
< Auto tuning can be used for both FM and AM (MW)
reception. >
(1) Use the AUTO/MANUAL tuning switch @ to
select the auto tuning mode or the manual tuning
mode.
e When the auto tuning mode is selected, the AUTO
TUNING indicator will now light.
(2) Use the BAND selector switch @ to select either
the FM or AM (MW or LW) reception band.
e For FM broadcasts, the "FM" and "MHz" indicators will
light.
e For AM broadcasts, the "AM" and "kHz" indicators will
light.
(3) Press the-(Down ) or + (Up) of the TUNING
switches © .
Auto tuning (FM, AM (MW)):
The tuner will automatically search for a broadcasting
station, and stop when one is found. To search for another
station, press again.
Manual tuning (FM, AM (MW, LW)):
The tuning frequency will change by one step each time the
switch is pressed. Press as many times as necessary to tune
in the desired station.
e If the switch is held depressed, the reception frequency
will change continuously, and stop when the switch is
released.
(4) When you wish to receive a different station
within the same band, repeat step (3). To receive
a station on a different reception band, repeat
steps (2) and (3).
(5) Adjust the volume and tone of the stereo amplifier.
NOTE:
When auto tuning is in use, reception may not be possible over
long distances or when signals are weak. At these times manual
tuning is recommended.
6
<ARE1087 >
Presetting FM and AM stations
You can preset 12 FM and AM stations in Mode 1, and 12
stations in Mode 2, that is a total of 24 stations.
(1) Use the BAND selector switch @ to select either
the FM or AM reception band.
e For FM broadcasts, the "FM" and "MHz" indicators will
light.
e For AM broadcasts, the "AM" and "kHz" indicators will
light.
(2) Use the TUNING switches @ to tune in the
desired station.
When memorizing an FM station, either press the FM
MONO switch @ to forcibly memorize the station
in the monaural mode, or memorize the station in the
auto stereo mode (with FM MONO switch @ left in
the OFF position).
(3) Press the MEMORY switch © .
e The display will flash (about 10 seconds).
rp Ci
(4) Press the STATION CALL switch @ .
e While the display is flashing, press the switch correspond-
ing to the station which you wish to preset or re-preset.
When presetting a station to Mode 1 (e.g. presetting
a station to No. 9):
By pressing the station call switch once, the station will be
preset to Mode 1 (1-12).
When presetting a station to Mode 2 (e.g. presetting
a station to No. 21):
By pressing the station call switch twice, the station will be
preset to Mode 2 (13-24).
e After you press the STATION CALL switch @ the display
will flash for about 2 seconds, then the station will be
memorized. If you press another switch while the display
is flashing, the station will not be memorized.