Publicidad
Idiomas disponibles
Idiomas disponibles
▶It is worth mentioning that the USB cable is included and the power
adapter is not included with the product.
PRECAUTIONS
▶It is important to take into account the following recommendations
for the use and cleaning of the product:
▶Avoid using rough objects, such as rough linen, brushes, or steel
balls, to scrub the detection window parts. Using these objects may
damage the sensor and cause product failure.
▶Do not clean the product with a damp cloth soaked in water or
dripping with water. This can affect the function of the sensor and
cause damage to the product. It is recommended to use a soft and
dry cloth to clean it.
▶Do not use strong acid or alkali to clean the product with detergent.
These products can be corrosive and damage both the sensor and
other parts of the product. Use mild, non-abrasive detergents for
cleaning.
▶When the faucet is not used for a long period, close the faucet
handle. This helps prevent unnecessary leaks or drips and saves
water.
▶Make sure the water supply pressure is within the range of
0.05-0.8 MPa. If the pressure is outside this range, there may be
water dripping or leaking. Check and adjust the water pressure as
necessary.
▶During the use of the product, make sure that the USB charging
protection plug is tightly fitted to ensure a safe connection. This will
prevent the entry of gas and oxidation of the charging port.
▶By following these recommendations, you will be able to keep the
product in good condition and ensure optimum performance in the
long term.
Instruction manual
TECHNICAL PARAMETERS
FAQ
FREQUENTLY ASKED QUESTIONS MANAGEMENT
Water leakage after installation:
▶1.1 Check for a gasket at the input connection and make sure it is
▶1.2 Confirm that the water pressure is within the recommended
NO WATER COMES OUT WHEN ACTIVATING THE SENSORS
▶2.1 Make sure the faucet handle and inlet angle valve are open and
▶2.2 Properly clean the surface of the upper and lower detection
▶2.3 Check that there are no obstacles located within 30 cm of the
▶2.4 Check if the sensor window indicator flashes once when
INTERMITTENT WATER OR INABILITY TO STOP THE FLOW
OF WATER
▶3.1 Clean any accumulation of water or other liquids on the surface
▶3.2 Check that there are no obstacles located within 30 cm of the
the proper thickness.
range of 0.05-0.8 MPa.
the water supply is active.
sensor area, making sure they are not covered with water or other
liquid.
detection areas of the upper and lower sensors.
detecting presence. If it blinks continuously or does not blink at all,
please be sure to charge the product before use..
of the upper and lower detection areas.
upper and lower detection areas.
ref. 01119
ES
PT
EN
FR
Publicidad
