Publicidad
Idiomas disponibles
Idiomas disponibles
For your safety
•
Read these instructions carefully before using your appliance for the first time. If the product is not used
according to the instructions this will void any guarantee and T-FAL cannot be held responsible.
•
This appliance complies with the technical rules and standards for safety currently in force (Electromagnetic
Compatibility, Low Voltage, environment).
•
This appliance is not intended for use by: children; or persons who may suffer from a mental and/or physical
impairment - unless they are adequately supervised in its operation and use.
Persons who have a limited or no understanding in the operation and use of this appliance must first read and
fully understand the contents of this instruction booklet, and where appropriate seek additional guidance on its
operation and use from the person responsible for their safety..
•
Warning ! The voltage of your electrical installation must correspond to that of the iron (110V-120V).
Connecting to the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee.
•
This iron must always be plugged into an earthed socket. If using a mains extension lead, ensure that it is
correctly rated (10A), with an earth.
•
If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Centre to
avoid any danger.
•
The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or has functional anomalies.
Never dismantle your appliance: have it inspected by an Approved Service Centre, so as to avoid any danger.
•
Never immerse your iron in water !
•
Before the tank is filled up, rinsed, emptied, or cleaned, the iron must be in the cordless position and removed
from its base.
•
Do not unplug your appliance by pulling on the cord. Always unplug your appliance: before filling or rinsing the
water tank, before cleaning it, after each use.
•
Never leave the appliance unattended when it is connected to a power source; nor if it has not cooled down for
approximately 1 hour.
•
Your appliance gives off steam, which may cause burns, especially when you are ironing on a corner or at the
edge of your ironing board. Never direct the steam towards people or animals.
•
Your iron should be used and placed on a flat, stable, heat-resistant surface. When you put the iron onto its iron
rest, make sure that the surface is stable.
•
Never leave your appliance plugged in inside its storage case (depending on the model)..
•
Always remove the storage case (depending on the model) before using the appliance.
•
Wait until the iron has cooled down before putting it away in its storage case.
•
This product has been designed for domestic use only. Any commercial use, inappropriate use or failure to
comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
•
The iron must only be used with the supplied iron rest.
Description
1.
Spray nozzle
2.
Anti-scale valve
3.
Steam control
4.
Filling inlet
5.
Spray Button
6.
Boost of steam button
7.
Ergonomic grip
8.
Temperature indicator light and
temperature setting indicator
9.
Thermostat dial
10.
Water tank max indicator
11.
Soleplate
12.
Storage case
(depending on model)
Preparation
•
Remove the storage case (depending on the model). To do so, press down
on the top part of the locking hooks then lift up the lid – fig.A.
Unravel the power cord.
•
•
Put the switch into the Corded position
•
You can use the attachment system –
Remove any labels
from the soleplate
before heating up the
iron.
fig.2
•
Before using your iron with the steam function for the first time, we recommend that
you operate it in a horizontal position for a few moments, away from your linen.
Under the same conditions, press the Boost of steam button
fig.4.
13.
Carrying handle
14.
Storage case locking and unlocking hooks
15.
Base
16.
System for attaching the base to your table
17.
Connection block
18.
Power cord clip
19.
Electric power cord
20.
3-position switch:
a.
Locking
b.
With power cord
c.
Without power cord
–
fig.1
and remove the iron from its base.
to attach the base to one side of your table – fig.3.
for the transport and storage of your iron
to iron with the flex
to iron without the flex
Please read these
instructions carefully.
Before first use
a few times –
ENG
5
Publicidad
