Publicidad
Idiomas disponibles
Idiomas disponibles
•
During the first few uses, a harmless odour and smoke may be given off. This has
no effect on the use of the iron and will disappear quickly.
If your water is very
hard, it is possible to
mix tap water with
store-bought distilled or
demineralised water in
the following
proportions:
- 50% tap water,
- 50% distilled or
demineralised water.
Filling the water tank
Put the switch into the Cordless position
•
and remove the iron from its base.
•
Set the steam control to
•
Place the iron flat and fill it – fig.7.
•
Put the iron back on its base.
Use
Adjust the temperature and the steam
•
Select the temperature (see table below or iron's heel) setting the thermostat facing the indicator – fig.8.
•
The thermostat light comes on –
•
Set the steam control –
RECOMMENDATIONS
FABRIC
LINEN
COTTON
WOOL
SILK
SYNTHETIC
(Polyester,Acetate, Acrylic, Nylon)
•
Your iron heats up quickly: so begin by ironing fabrics that are ironed at low tempe-
ratures first, then go on to those requiring a higher temperature.
•
If you turn down the thermostat, wait until the thermostat light comes back on be-
fore beginning to iron again.
•
When ironing fabrics with mixed fibres, set the ironing temperature for the most de-
licate fibre.
•
For delicate fabrics we recommend testing the fabric first on an inconspicious place
eg (inside the hem).
For optimum
efficiency, always put
your iron back on its
base.
Go back into Corded mode
Use this ironing mode for thicker fabrics that are difficult to iron or in cases where the burst of steam
often.
•
Put the switch into the Corded position.
You can start to iron as soon as the thermostat indicator light goes off.
If you have to use the
burst of steam button
frequently, use the
iron in the Corded
position.
6
•
Your appliance has been designed to operate using untreated tap water. However,
it is necessary to operate the Self-Clean function regularly in order to eliminate hard
water deposits from the steam chamber.
•
Heat concentrates the elements contained in water during evaporation.The types of
water listed below contain organic waste or mineral elements that can cause
spitting, brown staining, or premature wear of the appliance: water from clothes
dryers, scented or softened water, water from refrigerators, batteries or air
conditioners, boiled filtered or bottled mineral water, pure distilled or demineralised
water or rain water should not be used in your T-fal iron.
DRY
– fig.6.
fig.9.
It will go out when the soleplate is hot enough.
fig.10
to the desired position, consulting the table below.
Use this ironing mode for small garments and fabrics that are easy to iron.
Put the switch into the Cordless position
•
You can start to iron as soon as the thermostat indicator light goes off.
•
Press the burst of steam button
•
Wait a few seconds between each shot before pressing the burst of steam button
again.
–
fig.5
POSITION OF
THERMOSTAT CURSOR
MAX
•••
••
•
Go back into Cordless mode
– fig.1.
from time to time
What water to use ?
Attention: Always
remove your iron from
the base before filling it
up.Fill the tank up to
the"MAX".
Never fill the appliance
by holding it directly
under the tap.
= STEAM ZONE
STEAM SETTING
POSITION
In order to avoid water
dripping from the iron
onto the linen:
- Turn off the steam
when ironing silk or
synthetic fabrics.
- Set it at the minimum
position for wool.
– fig.5.
Obtain more steam
–
fig.4.
is used
Publicidad
