SICK WTM10L Instrucciones De Uso página 46

OPERATING INSTRUCTIONS
en
5 Electrical installation
5.1 Notes on electrical installation
46 O P E R A T I N G I N S T R U C T I O N S | WTM10L
Figure 6: Alignment of the sensor relative to the object direction
Note the preferred direction of the object relative to the sensor, cf.
sional drawings.
Mounting with the foreground suppression principle of operation
Figure 7: Alignment of the sensor
Note the preferred direction of the object relative to the sensor, cf.
Tightening torque
Note the sensor's maximum permissible tightening torque of < 0.56 Nm.
NOTICE
Equipment damage due to incorrect supply voltage!
An incorrect supply voltage may result in damage to the equipment.
Only operate the device with safety/protective extra-low voltage (SELV/PELV).
■
The sensor is a device of protection class III.
■
Only operate the device with an LPS (limited power source) in accordance with
■
IEC 62368-1 or an NEC Class 2 power supply unit.
figure 6 / Dimen‐
figure 7.
9382969/2024-02-23 | SICK
Subject to change without notice